Instructions - GE IM-G 3 Guía De Uso, Cuidado E Instalación

Installation Instructions
CAUTION: Unplug the
Refrigerator. To eliminate the
danger of electric shock during
installation, you must unplug
the refrigerator from its
electrical outlet.
Read each step thoroughly before proceeding.
Tools needed:
• Phillips-type screwdriver
• Blade-type screwdriver
• 5/16² Nutdriver
• Sharp knife
• Pliers
Step 1
C
B
• Remove the screw (A) that holds the
electrical plug cover in place. Discard
screw and cover.
• Remove the light shield insert (B) and
discard it.
• Loosen the two mounting screws (C)
approximately 1/2²(13 mm). DO NOT
REMOVE THESE SCREWS.
6
INSTALL THE ICEMAKER
Step 2
Cut the fill tube extension (8) to the
length (see the Fill Tube Extension section
at the back of this guide for the correct
length) with a sharp knife or single-edge
razor blade and slide it onto the fill tube
against the stop.
Step 3
On the
bottom
of the
icemaker,
loosely
fasten the
bracket (16) to the bottom rear of the
icemaker. The short leg of the bracket
should be pointing down from the
A
icemaker. Use the supplied bracket screw
using the existing hole in the icemaker.
Step 4
Place the
icemaker in
Cover
the freezer
removed
compartment
as shown.
Insert the
icemaker
power cord
plug (D) into
the socket on
the side wall, making sure the prongs
and holes are matched. Press the plug
firmly into the socket.
Step 5
• Lift the
icemaker so
the fill tube
extension
(8) fits in
the fill cup
opening
(E). Hang
the
icemaker
on the two
mounting screws (C).
8
C
C
16
D
8
C
E
(continued next column)
C
Step 5
(continued)
• Adjust the bracket on the bottom of the
icemaker so that it is against the plug.
Tighten the screw.
Make sure:
• The power cord is still firmly in
the socket.
• The fill tube extension (8) is still in the
fill cup opening—check the rear of the
refrigerator to make sure the fill tube
has not been pushed out of the back of
the refrigerator.
• The icemaker mounting screws are
located in the uppermost position of the
mounting slots.
THEN TIGHTEN THE ICEMAKER
MOUNTING SCREWS SECURELY.
Step 6
The icemaker
should feel secure
when you lift the
icemaker feeler
arm (F) to the
Arm down
STOP (up)
icemaker will
F
position. Leave it
operate
there until the
refrigerator is connected to the water
supply to prevent premature operation.
Step 7
Put the ice bucket
(9) directly under
the icemaker (to
the left and all the
way to the rear
of the shelf under
the icemaker).
NOTE: Check again to make sure the
icemaker power cord plug is fully inserted
into its socket with prongs matched to
corresponding holes.
Check again to make sure the icemaker
feeler arm (F) is in the STOP (up) position.
Step 8
The icemaker installation inside the
freezer compartment is now complete.
Continue to the Installing the Water Valve
Assembly section.
Arm up
stops
operation
F
9