Remove Existing Ice Cube Tray Holders; Reposition Freezer Shelf - GE IM-G 3 Guía De Uso, Cuidado E Instalación

REMOVE EXISTING ICE TRAY HOLDERS
Follow the instructions below for the ice tray holder that looks like yours.
Type 1
• Unhook the ice tray holder side and
bottom from the retaining hooks. Lower
the holder until the side is clear of the
freezer shelf and remove it from the
freezer. You will not need this part.
Type 4
Screws
Plastic hook
• Remove the 2 screws and save them for
installation of the icemaker.
• Lift the ice tray holder off the plastic
hook. You will not need this part.
You may need to reposition the freezer shelf so the icemaker and
bucket sit properly.
To reposition the two piece shelf supports: Slide the shelf up off the
base mount.
Follow Installation indicated by the label on
Retaining hooks
• As you lift the tab on the left side in the
holder with the blade of a screwdriver,
pull the holder forward and out. You
will not need this part.
• Remove the screw with a
• Pull the ice tray shelf away from the
wall. Remove the shelf. You will not
need this part.
• Replace the screw.

REPOSITION FREEZER SHELF

the back of the refrigerator—C, F or G.
Type 2
Do not
lift here
Lift this
tab out
Type 5
Screw
1/4" nutdriver.
Shelf
Support
Type 3
When following Instruction G, it is not
necessary to remove the ice tray shelf or,
on some models, the wire shelf next to it.
• Tilt the ice tray shelf and remove it. You
will not need this part.
Base
mount
5