Consumer Information - Moen L86940 Guia De Inicio Rapido

FLUSHING INSTRUCTIONS
IMPORTANT: Pipe chips, sand, stones and other solids found in new and renovated
plumbing can damage the sealing surfaces of the cartridge and cause leaks. To avoid
damage, DO NOT TURN ON SUPPLY VALVES until instructed below:
1. After installing and connecting your new faucet, make sure that the handles are in the on
or open position (rotate hot handle counterclockwise and cold handle clockwise).
DISASSEMBLY
1
1
6
NOTE: TURN OFF WATER BEFORE STARTING STEP 1.
CAUTION: Be careful not to damage the rubber seals on cartridge when re-installing cartridge.
!
During installation be sure of the following:
• Turn stem to ON position
• Key in cartridge fits into notch on valve body
1. Holding the lever or knob 2. Using a cartridge removal tool
handle (1) with one hand,
unscrew the handle hub
(6) counterclockwise as
shown above and set
aside.

CONSUMER INFORMATION

Faucets made of leaded brass alloys may contribute small amounts of lead to water that is allowed to stand in contact with the brass. The amount of lead contributed by any faucet is highest when
the faucet is new. The following steps may reduce potential exposure to lead from faucets and other parts of the plumbing system:
• Always run the water for a few seconds prior to use for drinking or cooking
• Use only cold water for drinking or cooking
• If you wish to flush the entire plumbing system of water that has been standing in the pipes or other fittings, run the cold water until the temperature of the water drops, indicating water coming
from the outside main
• If you are concerned about lead in your water, have your water tested by a certified laboratory in your area
Helpline
Call our toll free helpline number:
1 (800) 289-6 6 3 6
1 (800) BUY-MOEN
For answers to any product, installation
replacement parts, or warranty questions.
Hours of operation are:
8:00 A.M. - 8 P.M. EST. Monday - Friday
8: A.M. - 6:30 P.M. EST. Saturday
MOEN LIFETIME LIMITED WARRANTY
Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the original consumer purchaser for as long as the original consumer
purchaser owns their home (the "Warranty Period" for homeowners), that this faucet will be leak and drip-free during normal use and all parts and finishes of this faucet will be free from defects in
material and manufacturing workmanship. All other purchasers (including purchasers for industrial, commercial and business use) are warranted for a period of 5 years from the original date of
purchase (the "Warranty Period" for non-homeowners).
If this faucet should ever develop a leak or drip during the Warranty Period, Moen will FREE OF CHARGE provide the parts necessary to put the faucet back in good working condition and will
replace FREE OF CHARGE, any part or finish that proves defective in material and manufacturing workmanship, under normal installation, use and service. Replacement parts may be obtained by
calling 1-800-289-6636 (Canada 1-800-465-6130), or by writing to the address shown. Proof of purchase (original sales receipt) from the original consumer purchaser must accompany all warranty
claims. Defects or damage caused by the use of other than genuine Moen parts are not covered by this warranty. This warranty is applicable only to faucets purchased after December 1995 and
shall be effective from the date of purchase as shown on purchaser's receipt.
This warranty is extensive in that it covers replacement of all defective parts and finishes. However, damage due to installation error, product abuse, product misuse, or use of cleaners
containing abrasives, alcohol or other organic solvents, whether performed by a contractor, service company, or yourself, are excluded from this warranty. Moen will not be responsible for labor
charges and/or damage incurred in installation, repair or replacement, nor for any indirect, incidental or consequential damages, losses, injury or costs of any nature relating to this faucet. Except as
provided by law, this warranty is in lieu of and excludes all other warranties, conditions and guarantees, whether expressed or implied, statutory or otherwise, including without restriction those of
merchantability or of fitness for use.
Some states, provinces and nations do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty
gives you specific legal rights and you may also have other rights which vary from state to state, province to province, nation to nation. Moen will advise you of the procedure to follow in making
warranty claims. Simply write to Moen Incorporated using the address below. Explain the defect and include proof of purchase and your name, address, area code and telephone number.
3
Moen Incorporated • 25300 Al Moen Drive • North Olmsted, OH 44070-8022 U.S.A. Au Canada, Moen inc., 2816 rue Bristol, Oakville (Ontario), L6H 5S7
2
C
B
D
E
A
• Waterway holes in cartridge are lined up
(not included) (B), unscrew the
escutcheon adjuster (A) and the
cartridge nut (D).
7:30 A.M. - 5:00 P.M. EST. Monday - Friday
7:30 A.M. - 5:00 P.M. EST. Monday - Friday
Visit our website at www.moen.com for more information
2. Open hot and cold water shut off valves and allow the water to run for 15 seconds.
3. Turn off hot and cold cartridges and check the system for leaks.
4. Unscrew Aerator from the end of the spout and clean the screen.
5. Replace the Aerator and check for leaks.
3
C
4. For reassembly, drop stem extension with cartridge as one unit into
key
3. Grasp stem extension (C)
with pliers being careful
not to damage threads,
pull straight upward
removing stem extension (C)
and cartridge (E) as one unit.
In Canada:
1-800-465-6130
Hours of operation are :
Toronto:
1-905-829-3400
Hours of operation are :
4
B
C
A
E
D
valve body, press down until it bottoms. Align key to notch in valve body by
slowly rotating the stem extension clockwise while still pressing down. This will
align the "KEY" on the cartridge with the "NOTCH" in the valve body. When
enters notch you will feel it drop in, then the cartridge will be in place. To be
certain, rotate stem extension clockwise and then counterclockwise. You
should feel cartridge stop in both directions. If so, the cartridge is in place. Do
not turn on water yet. Using a cartridge removal tool (not included) (B),
reinstall cartridge nut (D) until it bottoms (DO NOT CROSS THREAD).
Reinstall escutcheon adjuster (A). Check system for leaks.
In Mexico:
(84) 88-08-26, 88-08-27,
o 91-800-84345
Hours of operation are :
8:00 A.M. - 8 P.M. EST. Monday - Friday
8: A.M. - 6:30 P.M. EST. Saturday
➤
STEM
➤ KEY
➤ Notch in
NOTCH
valve body