Mechanical Installation; Intended Use; Safety Instructions - Balluff BSP B S1B Serie Manual Del Usuario

Pressure Sensors with IO-Link
BSP-B... /-V...
EU Directive 2004/108/EC (EMC Directive) and EMC Law
Generic Standards: EN 61000-6-4 (Emissions), EN 61000-6-2 (Interference Immunity)
Emission testing: Radio interference emission EN 55011 Group 1, Classes A and B
Scope
This guide is valid for the following pressure sensors:
– BSP Bxxx-xxxxx-xxxS1B-xx
– BSP Vxxx-xxxxx-xxxS1B-xx
High-end
Standard

Intended use

The pressure sensor was developed to monitor the pres-
sure of gases or fluids compatible with stainless steel,
ceramics and fluoroelastomers. Pressure sensors are
suited to different types of application depending on the
device and mechanical connection.
The pressure sensor is installed in a machine or
integrated into a system. Flawless function in accordance
with the specifications in the technical data is ensured only
when using original BALLUFF accessories, and use of any
other components will void the warranty.
Modifications to the sensor or non-approved use are not
permitted and will result in loss of warranty and void any
liability claims against the manufacturer.

Safety instructions

Before commissioning, read the user's guide
carefully!
These sensors must not be used in applications
in which the safety of persons is dependent on
the function of the device (not a safety compo-
nent acc. to EU Machinery Directive).
Installation and startup are to be performed only by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take measures to ensure
that a defect in the object detection system will not result
in hazards to persons or equipment.
If defects or non-clearable faults in the sensor occur, take it
out of service and secure against unauthorized use.
www.balluff.com
Downloading the user's guide
The user's guide can also be found on the Internet at
www.balluff.com.

Mechanical installation

– Always depressurize and disconnect pressure sensors
from the power supply before installing!
Flush-mounted
high-end
– Observe the following when installing outdoors or in a
damp environment:
Select a installation location that allows splash and
condensation water to drain away. Fluids must not be
allowed to accumulate on sealing surfaces!
Connect the device to the power supply immediately
after installation to prevent moisture from entering the
connector. Otherwise fit a suitable protective cap to
prevent the ingress of moisture. The degree of protec-
tion specified on the data sheet only applies if the
device is connected!
If there is a risk of damage from lightning or excess
voltage, mount overvoltage protection between the
power supply unit or switching cabinet and device.
– On hydraulic systems, position the device so that the
pressure connection faces upwards (venting).
– If the device is installed on a steam pipeline, provide a
cooling section.
– Install the device in a location protected from direct
sunlight. Sunlight can damage or affect the functional
capability of the device.
– When installing devices with a relative reference in the
housing (no borehole next to the electrical connection),
make sure that the relative reference required for the
measurement is protected against dirt and moisture. If
the device is exposed to fluids, the relative reference
blocks the air pressure compensator. Accurate mea-
surements are not possible when this happens and the
device may be damaged.
– No mechanical tension should be placed on the pres-
sure connection during installation as this may shift the
characteristic curve. This applies in particular to
extremely small pressure ranges and devices with a
plastic pressure connection.
Caution!
The pressure sensor may not be exposed to
high temperatures or rapid increases in pressure
that extend beyond specific limits (see Technical
Data for limit values).
Do not touch the sensitive membrane of the
flush-mounted sensor: it can tear or become
deformed.
English 1