Transport And Storage - Orascoptic ZEON ENDEAVOUR Serie Instrucciones De Uso Y Cuidado

Tabla de contenido

Idiomas disponibles

Operating Your Zeon Endeavour Series

Connecting the Cable to the Headlight

The Zeon Endeavour series cable attaches to the top of the headlight. The cable can easily detach from the

headlight, allowing the user to uncouple their loupe from the cable and battery pack. When connecting the

cable to the headlight, it is important to push the cable down firmly until it is completely flush

against the headlight. This will reduce any chance of fluid ingress while also ensuring a stable electrical

connection. If you experience issues with the headlight flickering on and off, or not turning on at all, ensure

the cable has not come loose.

Using the Curing Filter

The curing filter should be used when working with light-cured composites. When applying these materials,

unfiltered light from the headlight can cause premature curing of the composite. The curing filter is made up of

two components; the black bezel ring that is secured to the end of the headlight and the orange filter that can be

flipped up and down as needed during procedures.

• If you don't require the curing filter for your practice, you can remove it from the headlight. To remove

the curing filter, flip the orange filter to the UP-position and carefully pull the black bezel ring off the

headlight. Do not pull on the orange curing filter itself.

• To attach the curing filter, flip the orange filter to the UP-position and carefully push the black bezel ring

onto the headlight, making sure the hinge is at the top. Do not push on the orange curing filter itself.