Diamond GRAN GALA 12+12 Manual Del Usuario página 6

7.
CONNECTION TO THE MAINS
1 . Ensure that the current and frequency of the mains supply are the same as those indicated on the
plate attached to rear side of appliance, next to the control board. . Ensure that the supply socket:
I
properly earthed; b) fulfils the requirements of the rated current as set out on the rating plate; c) complies
with the IEC regulations:- thermo-magnetic differential switch (ground fault interrupter) with In = rated
UK
value as stated on the rating plate and ID sensitivity of 30 mA.
explosion (AD) in the room. . The cable of the appliance is H05 VVF, designed for internal use. For
D
installation in other than internal settings, it will be necessary to replace the cable with the appropriate
type (for example H07 VVF for external settings). . Insert the plug in the socket (do not use three-way
E
adapters and reduction adapters).
F
8.
CHECKING CORRECT OPERATION BEFORE USE
Make sure that: 1.
NL 3 .the lights are turned on; . thermometer shows the desired temperature for the goods to be stored;
5. appliance is not exposed to direct sunlight or to powerful lamps; . ambient temperature does not
exceed +30°C with 55% R.H. (climatic class 4);
P
compartment; there is a clearance of at least 30 cm in front of the grill.
S
9. ADJUSTMENTS
The control unit is supplied with standard setting.
DK
alarms are active, the word
the value will appear on the display, to change it use the
FIN
1. Control unit
fig. 3)
B
MANUAL OPERATION AND DEFROSTING
10.
Press down the "Up" key for five seconds. If the conditions are not suitable, the display will flash 3 times.
GR
REPLACING THE INTERNAL LIGHT BULBS
11.
CZ
1. Lift the curtain and empty the glass cabinet.
shelves in the glass cabinet, protected by an opaline glass cover.
EE
glass cover on one side and pulling it out, turning downwards, then turn the light bulb to free it from its
seat. (see fig. 4)
LV
LT
H
M
PL
SK
SLO
Operator's guide
4
6. Turn on the refrigeration switch
the plug is connected; . the refrigeration unit switch is turned on (green light lit up);
4
"set" appears. To view the
2. Lighting button. 3. Glass cabinet ON switch
2
3 . Ensure that there is no danger of
5
2
6
7. there is sufficient ventilation for the motor
To set the temperature
SETPOINT value, press the
"Up" and "Down"
4. Lock warning light
2. The light bulbs are located inside the two internal
3.
6
press the "set" key. If no
"set" key once more;
keys. Description of controls:
5. Power switch (see
Remove the guard by unhooking the
a) is