Forch GO-5001 Manual De Instrucciones página 36

7. TROUBLESHOOTING
Defect
Rivetting mandrel does
not brake
Clamping jaws are sliding
on the mandrel
Mandrel cannot be
positioned into the
mouthpiece
Rest of mandrel cannot be
sucked into the mandrel
collecting tank
8. Spare parts list (drawing on the last page)
Article number
2722 1718 24
2722 1718 30
2722 1718 40
2722 1718 48
2722 1718 1
2722 1718 2
2722 18 1
2722 1718 3
2722 1718 4
2722 1718 5
2722 18 2
2722 18 3
Accessory package
Possible causes
1.3-pcs set of clamping
jaws is worn out or
damaged
2.insufficient amount of
hydraulic oil in the device
3.air supply with insufficient
pressure
1.3-pcs set of clamping
jaws is worn out
2. metallic chips between
the clamping jaws
3. pusher spring too weak
1.selected mouthpiece
size is wrong
2. clamping jaws are stuck,
rest of mandrel is not
released
1.Suction power for
mandrel release is mandrel,
insufficient
2.air supply with low
pressure
Description
GO-5000/5001 - Mouthpiece A 2,4
GO-5000/5001 - Mouthpiece B 3,0/3,2
GO-5000/5001 - Mouthpiece C 4,0
GO-5000/5001 - Mouthpiece E 4,8/5,0
GO-5000/5001 – Steel socket
GO-5000/5001 – Clamping jaw socket
GO-5001 – Clamping jaw
GO-5000/5001 – Compressed air inlet
GO-5000/5001 – Counter-nut
GO-5000/5001 – Collecting tank
GO-5001 – Slide feed for clamping jaws
GO-5001 – Spring for slide feed for clamping jaws
Solutions
1.exchange 3-pcs set of
clamping jaws
2. refill hydraulic oil
3. increase the pressure of
the supplied compressed air
within the specified range
1.exchange 3-pcs set of
clamping jaws
2. clean the clamping jaws
3. exchange pusher spring
1.use correct mouthpiece
size
2. remove residues of mandrel
by disassembling of the front
socket and the pillar terminal
1.increase suction power for
see device manual
section 5
2. increase pressure of air
supply within specification