Care And Maintenance; Troubleshooting - Harbor Breeze PLM52CB5D Manual De Instrucciones

CARE AND MAINTENANCE

At least twice each year, lower canopy (B) to check downrod (A) assembly, and then tighten all
screws on the fan. Clean motor housing (D) with only a soft brush or lint-free cloth to avoid
scratching the finish. Clean blades (H) with a lint-free cloth. You may occasionally apply a light coat
of furniture polish to wood blades for added protection.
Important: Shut off main power supply before beginning any maintenance. Do not use water or a
damp cloth to clean the ceiling fan.

TROUBLESHOOTING

If you have any questions regarding the product please call customer service at 1-800-527-1292, 8:30
a.m. - 5 p.m., CST, Monday - Friday.
Warning: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does not move.
Noisy operation.
Excessive wobbling.
Note: A small amount of "wobble" is normal and should not be considered a defect.
POSSIBLE CAUSE
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Faulty wire connection.
4. Plugs not connected properly.
1. Blades (H) are loose.
2. Cracked blade (H).
3. Unapproved speed control.
1. Blades (H) are loose.
2. Blade arms (P) incorrectly
installed.
3. Unbalanced blades (H).
4. Fan not securely mounted.
5. Fan too close to vaulted ceiling.
6. Set screw(s) on motor housing
yoke is (are) not tightened
properly.
7. Set screw on hanging ball is not
tightened properly.
CORRECTIVE ACTION
1. Push switch firmly either way.
2. Turn power on or check fuse.
3. Turn power off. Loosen canopy
(B) and check all connections.
4. Check that male and female
plugs in switch housing (E) are
connected properly according to
instructions on page 12.
1. Check to be sure plastic locking
mechanisms (G) are secure.
2. Replace blade (H).
3. Replace with an approved
speed control device.
1. Check to be sure plastic locking
mechanisms (G) are secure.
2. Re-install blade arms (P).
3. Switch one blade (H) with a
blade (H) from the opposite side.
4. Turn power off. Carefully loosen
canopy (B) and verify that
mounting bracket (C) is secure.
5. Use a longer downrod (A) or
move fan to another location.
6. Tighten yoke set screw(s)
securely.
7. Carefully loosen and lower
canopy (B) and verify that set
screw on hanging ball is tightened
securely.