ESYLUX PD 360i/8 DALI ADR Manual De Instrucciones página 16

Switch ON/OFF manually
Lighting for 8 hours permanently ON or OFF.
8 h ON
GB The lighting remains constantly switched on for
8 hours. 8 h ON mode is indicated by the LED
flashing in a sequence of 1 second ON and 5
seconds OFF. In this mode, the detector does not
respond to presence. To exit this mode, press the
8 h ON button.
8 h OFF
The lighting is constantly switched off for 8 hours.
8 h OFF mode is indicated by the LED flashing
in a sequence of 1 second ON and 5 seconds
OFF. In this mode, the detector does not respond
to presence. To exit this mode, press the 8 h OFF
button.
Setting the brightness set value (10 lux - 2000 lux)
Press the buttons to adjust the brightness set
value. The addition function can also be used.
Automatic storage of the current light value
individually stores the current light value (as
switch-on value) at the touch of a button.
16
Setting the switch-off delay time
If no movement is detected, the switch-off delay
time starts.
1 minute 10 minutes
3 minutes 30 minutes
5 minutes 50 minutes
Other values can be created with the "addition function".
Switch between fully automatic and semi-automatic mode
for light channel
For semi-automatic mode, the LED lights up for
approximately 4 seconds.
For fully automatic mode, the LED flashes 20 times.
Addition function
This button is for adding together 2 values of the
same unit (lux/switch-off delay time of lighting,
lux/switch-off delay time of orientation light).
Example: 50 lux + 150 lux = 200 lux
1 min. + 5 min. = 6 min.
Restore factory settings
Confirmed by flashing red LED on the detector.
The presence detector operates according to the
potentiometer settings.