Operating The Pump - K2 Pumps UTA02502K Manual Del Propietário

OPERATION
NOTE: Make certain you unwind the garden hose completely. Kinks in the hose will restrict the pump, preventing it from
priming, which is the first step to pumping water. This pump has water detector sensors. As long as the water level is
over 1-1/4 in., the pump will automatically start operating.
Plugging in the pump
 Place the pump on a solid base in a flooded area or any place that
you would like to remove water. Plug the pump into a 115 volt GFCI
power outlet.
WARNING: Do not allow the plug to fall in water and do not stand in
water while the pump is plugged in.
WARNING: Do not handle the pump or pump motor with wet hands or
when standing on a wet or damp surface, or in water while the pump is
plugged in.
NOTE: Place upright on a solid base..

Operating the pump

If the water level is over starting level 1 1/4 in, the pump will

automatically start and pump out water until the water level is down
to 1/4 in. When water reaches starting level 1 1/4 in again, the pump
will start again.
NOTE: The pump will not start working unless the water level is over 1-1/4 in.
For Professional Technical Support call 1-844-242-2475 5