Allen + Roth VICTORIA HARBOR LP8242LCH Manual Del Usuario página 8

ASSEMBLY INSTRUCTIONS
6. Reinstall the hanger ball on the downrod (C)
by routing the two 54 in. wires from the motor
assembly (A) through the hanger ball. Position
the pin removed in step 1 through the two
holes in the downrod (C) and align the hanger
ball so the pin is captured in the groove in the
top of the hanger ball. Pull the hanger ball up
tight against the pin. Securely tighten the
preassembled set screw in the hanger ball.
CAUTION
A loose set screw could result in a wobbly fan.
7. Cut off excess lead wire approximately 6 to 9
in. above top of the top of the downrod (C).
Strip insulation off 1/2 in. from the end of each
lead wire.
6
7
8
C
Lowes.com/allenandroth
C