Sdi Audio De-Embed Table - Blackmagic Design Teranex Mini Manual De Instalación Y Funcionamiento

5. Optical S/PDIF Audio Output
S/PDIF Signal with TOSLINK Connector.
6. L - Unbalanced Analog Line Level Output
Unbalanced left channel analog audio output RCA
connector.
7. R - Unbalanced Analog Line Level Output
Unbalanced right channel analog audio output RCA
connector.
8. Ethernet PoE
Connects to a network switch or computer so you can
change settings using Blackmagic Teranex Setup. The
Ethernet port also supports power over Ethernet.
Switches
Teranex Mini SDI to Audio 12G's switches provide the
following settings:
Switch 8 - Analog Audio, AES/EBU Audio
Set switch 8 to OFF to select balanced analog audio, or to
ON for digital AES/EBU audio output.
Switch 7 - Output Audio/Timecode
Set switch 7 to 'on' to output timecode via the R channel
audio XLR connector. Set to 'off' to output audio.
Switches 6, 5, 4 - SDI Audio De-Embed Bit 2, 1, 0
Switches 6, 5 and 4 are represented as bits 2, 1 and 0
respectively. This simply means that by setting various
on/off combinations for switches 6, 5 and 4, you can choose
which audio channels to de-embed from the SDI input
signal into your audio output.

SDI Audio De-Embed Table

Analog Audio Channels
1-2
3-4
5-6
7-8
9-10
11-12
13-14
9. SDI In
SDI video input BNC connector.
10. SDI Loop Out
SDI video loop output BNC connector.
11. L - Analog or AES/EBU
Balanced left channel analog audio, or digital AES/EBU
audio output XLR connector.
12. R - Analog, AES/EBU or Timecode
Balanced right channel analog audio, or digital AES/EBU
audio output XLR connector. Can also be configured for
timecode output.
The switch legend on the base of your converter gives you all
the information you need to change conversion settings.
Switch 6 Switch 5
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
27
Switch 4 Switch Diagram
OFF
ON
OFF
ON
OFF
ON
OFF