Safety Precautions; Using Precautions - Mitsubishi Electric EY-3D-EMT1 Manual De Usuario

Safety precautions

WARNING:
Contact your dealer if there is something wrong with your 3D Emitter.
Do not operate if smoke, strange noise or odor comes out of your projector. It
might cause fi re or electric shock. In this case, contact your dealer immediately.
Do not keep using the damaged 3D Emitter.
It can lead to fi re or electric shock.
Do not drop or modify your 3D Emitter.
It can lead to breakdown or other failure.
CAUTION:
Not for use in a computer room as defi ned in the Standard for the Protection of
Electronic Computer/Data Processing Equipment, ANSI/NFPA 75.

Using precautions

This 3D Emitter is used only for Mitsubishi projectors supporting 3D
images.
Use this 3D Emitter only for viewing 3D images on the supported Mitsubishi
projectors.
The 3D Glasses work by receiving an infra-red light from the 3D Emitter. Other
infra-red communication devices, lighting fi xtures, or heating appliances placed
near the 3D Emitter may affect the operation of the 3D Glasses.
View 3D images within the specifi ed signal reception range. (See the illustration
of "Transmission range of the infra-red signal.")
The signal of the 3D Emitter may be affected by that of the infra-red remote
control. In such a case, change the orientation of the 3D Emitter.
A remote control may operate improperly while you watch the 3D images,
however, it is not a malfunction.
When using the device in Europe:
COMPLIANCE NOTICE
This device complies with the requirements of the EC Directive 2004/108/EC
"EMC Directive" and 2006/95/EC "Low Voltage Directive".
The electro-magnetic susceptibility has been chosen at a level that gains proper
operation in residential areas, on business and light industrial premises and on
small-scale enterprises, inside as well as outside of the buildings.
EN-2