Mitsubishi Electric EY-3D-EMT1 Manual De Usuario página 8

Installation and connection (continued)
Placing the 3D Emitter in an arbitrary place
Preparation:
Turn off the power of the projector.
1. Put the infra-red transmission part
of the 3D Emitter into the base part.
2. Secure temporarily the 3D Emitter in
an arbitrary place (such as the wall
around the screen).
3. Connect the 3D Emitter terminal on
the 3D Emitter to the 3D EMITTER
terminal on the projector using the
supplied mini DIN 5-pin cable (15 m).
4. Turn on the power of the projector
and make settings for viewing 3D
images.
• For details, see the User Manual
supplied with the projector.
5. Prepare the 3D Glasses.
6. Adjust the position and angle of the
3D Emitter so that the 3D Glasses
can receive the infra-red signal.
• After completing the adjustment,
fi x the 3D Emitter fi rmly using the
supplied double-sided tape, etc.
EN-8
To 3D To 3D
Emitter EMITTER
terminal terminal
Mini DIN 5-pin cable (15 m)