Installation And Connection - Mitsubishi Electric EY-3D-EMT1 Manual De Usuario

Installation and connection

Transmission range of the infra-red signal
This 3D Emitter transmits the infra-red signal in the range illustrated below.
View from the side
The above figures are approximate and may be slightly different from the
actual measurements.
Place the 3D Emitter so that you can use the 3D Glasses within the transmission
range described above.
Normally, attach the 3D Emitter to the projector as described on page 7.
However, if the 3D Glasses don't receive the signal properly when you attach
the 3D Emitter to the projector, place the 3D Emitter according to the procedure
described on page 8.
• Do not put any object which obstructs the communication between the 3D
Emitter and the 3D Glasses.
• Do not place the 3D Emitter near the remote control sensor of other devices.
• The transmission distance is decreased when the infra-red signal from the
3D Emitter is transmitted to the 3D Glasses by refl ecting on the screen. In
addition, the transmission distance in such case varies depending on the
characteristics of the screen.
EN-6
The transmission angle
can be adjusted
vertically in five steps by
switching the angle of
the transmission part.
10 m
View from the top