Mitsubishi Electric EY-3D-EMT1 Manual De Usuario página 7

Attaching the 3D Emitter to the projector
Preparation:
Turn off the power of the projector.
1. Remove the caps covering the
3D Emitter attaching part on the
projector.
2. Secure the base part of the 3D
Emitter to the 3D Emitter attaching
part on the projector using the
supplied screws.
3. Put the infra-red transmission part
of the 3D Emitter into the base part.
4. Connect the 3D Emitter terminal on
the 3D Emitter to the 3D EMITTER
terminal on the projector using the
supplied mini DIN 5-pin cable (1 m).
5. Turn on the power of the projector
and make settings for viewing 3D
images.
• For details, see the User Manual
supplied with the projector.
6. Prepare the 3D Glasses.
7. Adjust the vertical angle of the 3D
Emitter so that the 3D Glasses can
receive the infra-red signal.
To 3D Emitter
terminal
Mini DIN 5-pin cable (1 m)
To 3D EMITTER
terminal
EN-7