Maintenance And Storage - Ninebot Mecha Kit Manual Del Usuario

Maintenance and Storage:

1. Install the lithium battery pack in the Mecha Kit as instructed and ensure the battery pack is within the sealed plastic
encapsulation and has sufficient power prior to using the Kit. It is prohibited to use third-party batteries or battery packs
in the Mecha Kit, which may result in damage to the control panel; never use any third-party chargers to charge the
lithium battery, or otherwise, there may be a risk of fire or explosion.
2. Do not attempt to destroy or disassemble the battery as it contains harmful substances.
3. Before your drive, ensure the battery can provide sufficient battery to prevent any potential danger caused by the battery
being low or dead.
4. After plugging the charging cable into the correct port (100–240V/50–60Hz), keep the Mecha out of the reach of
children and pets and place it in an isolated area away from flammable objects.
5. Pay attention to different data and parameters associated with different models, which are subject to change without
further notice.
6. Before starting the cleaning process, ensure that both the Mecha Kit and the self-balancing vehicle are turned off. Ensure
the Mecha Kit's battery has been removed from the battery compartment.
7. Pay attention to the following matters if you drive the Mecha during the summer: store the Mecha in a safe environment
with temperatures no higher than 122 °F / 50 °C and avoid having the Mecha exposed to the sun outdoors for a long
time.
8. Pay attention to the following matters if you drive the Mecha in winter: store the Mecha in a safe environment with
temperatures no lower than -4 °F / -20 °C. If the storage temperature is below 32 °F / 0 °C, place the Mecha in a warm
environment (with the temperature above 50 °F / 10 °C) before charging.
Launcher:
1. Wear goggles and protective equipment when using the launcher to protect your face, eyes, and other body parts.
2. Do not launch water bullets at people, animals, or others' property or direct the ballistic light of the launcher at a person's
eyes.
3. Never aim water bullets at any person's head, face, eyes, or other parts of the body.
4. Observe the surrounding environment before your drive to ensure that the place is wide and open enough for gaming.
Water bullets:
1. Use original Ninebot water bullets for the Mecha Kit; otherwise, it may cause a malfunction of the launcher.
2. Be careful as launched water bullets may cause personal injury and property loss.
3. Have experienced personnel present to instruct or supervise the operation of the Mecha Kit when gaming with water
bullets.
06
4. Empty water bullets in the bullet case at the end of each drive and ensure that all water bullets inside the launcher have
been fired.
5. Do not put water bullets that swell in water into the mouth, nose, or ears. This may be a choking hazard. Additionally, keep
them out of the reach of children and pets to avoid choking, gastrointestinal rupture, or other injuries caused by
accidental swallowing or inhalation.
6. Do not freeze water bullets that have been swollen to prevent them from clogging the launcher or increasing the risk of
danger or injury.
7. Never fire projectiles that are not part of the Mecha Kit, such as pencil tips, nails, and rocks. If such behavior occurs, it
should be stopped immediately.
USB charging cable:
1. The charging cable is only compatible with the rechargeable battery pack of the Mecha Kit.
2. The charging cable is only compatible with 5V/1–2A USB power adapters. Using other adapters may lead to charging
failure, and the charging cable or the battery may be damaged.
3. The direction of the plug should be correct. Forceful plugging is to be avoided to protect the charging cable or battery
from being damaged by the short-circuiting of plug pins.
4. When not in use, the charging cable should be removed from the power adapter and stored in a cool place that is not
exposed to moisture, direct sunlight, etc.
5. There is a high likelihood of the charging cable being damaged in the following circumstances: the charging cable is
connected to the power supply for too long, short-circuiting of metal pins in the plug, a heavy fall, high pressure, etc.
07