Mode Change In The App; Assembling And Disassembling The Mecha - Ninebot Mecha Kit Manual Del Usuario

3. Mode Change in the App

Before the assembly, you should switch the mode in the Segway-Ninebot app ( referred to as "the app").
1 Download and install the app
Scan the QR code.
Segway-Ninebot app
* Bluetooth version 4.1 or above is required.
2 Pair your Ninebot S with your mobile device
Turn on Bluetooth.
Power on the Ninebot S.
Search your vehicle in the app to connect and
pair it.
Searching
One or more automatic firmware updates may occur during the process.
How to check the firmware status: Vehicle ＞ Sidebar ＞ Firmware update (Up to date).
If the firmware version is not up-to-date, please update the firmware to the latest version before changing mode.
10
Search Segway or Ninebot in the App
Store or Google Play to download it.
Segway-Ninebot
3 Change mode
Vehicle > Sidebar > Mode change > Mecha mode.
* If the mode is changed successfully, the Bluetooth
connection will be disconnected automatically.
Switch driving mode
Ninebot S xxx
Unknown Self-balancing mode
Settings
Mecha mode
Only available when the Ninebot Mecha Kit
Switch driving mode is installed.
Self-balancing mode
Basic info
New Rider Tutorial

4. Assembling and Disassembling the Mecha

The following pictures show the assembling steps between a Mecha Kit and a Ninebot S
(after its steering bar was removed*).
* Refer to "Appendix 5: Steering bar removal instructions".
The assembling should ONLY be done by adults. DO NOT power on the vehicle during
assembling or disassembling.
Assembling
1 Install the seat by tightening the 4 screws.
3 Install both the left and the right armrests.
* The LOGO side of armrest should face outward.
a. Slide the buckle cover on the b. Locate the plug wire on the
side of the armrest to open it. side of the frame that
supports the armrest.
Scan the QR code to watch
the assembly instructions.
Remove the covers of the foam stickers and affix them
2
to where the screws are installed.
c. Pass the plug wire through the hole
at the bottom of the armrest and
connect it with the matching plug
wire in the armrest.
Slide the buckle cover to close it.
11