Connecting To The Battery - Trueshopping CT1AMBCM Guia Del Usuario

6) Since this is a battery maintainer and you will keep it connected with vehicle battery for a
long time, do monitor monthly. Follow the battery manufacturer's instructions for adding
distilled water if applicable.
7) Following is the charger's technical specification:
AC Input
DC Output
Start Voltage
Housing Protection
Battery Type
Accessories Included
Ambient Temperature

CONNECTING TO THE BATTERY

1) Identify polarity of battery posts. The positive battery terminal is typically marked by
these letters or symbol (POS,P,+). The negative battery terminal is typically marked by
these letters or symbol (NEG,N,-).
2) Do not make any connections to the carburettor, fuel lines, or thin metal parts.
3) Identify if you have a negative or positive grounded vehicle. This can be done by
identifying which battery post (NEG or POS) is connected to the chassis.
4) For a negative grounded vehicle (most common): connect the RED POSITIVE clamp /
ring connector first to the positive battery terminal, then connect the BLACK NEGATIVE
clamp / ring connector to the negative battery terminal or vehicle chassis.
5) For a positive grounded vehicle (very uncommon): connect the BLACK NEGATIVE
clamp / ring connector first to the negative battery terminal, then connect the RED
POSITIVE clamp / ring connector to the positive battery terminal or vehicle chassis.
6) When disconnecting, disconnect in the reverse sequence, removing the negative first (or
positive first for positive ground systems).
7) Follow these steps when using 12V accessory plug (CT1AMBCM does not have this
accessory) keep the vehicle hood open. Connect the end of the 12V accessory plug to the
charger; insert the 12V accessory plug into the vehicle's 12V outlet. If the vehicle's
220-240VAC, 50-60Hz, 0.5A
12VDC, 1A;
6VDC, 1A
> 1V
IP54
All Types of 6V and 12V Lead-acid
Batteries
Clamp Connectors, Ring Connectors
0℃ ~ +40℃