LUND SR2 Instrucciones De Instalación página 3

9. Level and adjust the Running Board as necessary and fully tighten all hardware.
10. Repeat Steps 2—8 for passenger side Running Board installation.
11. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used to clean the Running Board.
(Fig 1) Driver/left side mounting locations
Front
(Fig 3) Slide (2) 8mm Clip Nuts into
rectangular opening
99-16 FORD 250/350/450/550 SUPERDUTY SUPERCREW
Driver Side Installation Pictured
Front
(2) 8mm Clip Nuts
(2) 8mm Hex Bolts
(4) 8mm Flat Washers
(2) 8mm Nylon Lock Nuts
SR2 RUNNING BOARDS
Front
(Fig 2) Driver/left front mounting location
Front
(Fig 4) Driver side Mounting Bracket assembly
Page 2 of 4
(2) 8mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
11/10/17 (RA)