Parts List - LUND SR2 Instrucciones De Instalación

PARTS LIST:

2 SR2 Running Boards(91")
3 Driver/left side Mounting Brackets
3 Passenger/right side Mounting Brackets
24 8-1.25mm x 30mm Hex Bolts
12 8mm Clip Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting on the driver front side of the vehicle, locate the (2) holes through the bottom of the pinch weld.
Next, locate the rectangular opening and the (2) small hole in the inner body panel directly above the
holes in the pinch weld, (Figures 1 & 2). NOTE: The holes in the inner panel may be covered with
sealing tape or insulation, remove as required.
3. Slide (2) 8mm "U" Clips into the rectangular opening with the nut towards the inside. Line up the
threaded nut on the clips with the (2) small round holes, (Figure 3).
4. Select (1) Driver side Mounting Bracket. Attach the top of the Bracket to the "U" Clips with (2) 8mm Hex
Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figures 4 & 5). Line up the lower holes in
the Bracket with the (2) holes through the pinch weld. Bolt the Bracket to the pinch weld with (2) 8mm
Hex Bolts, (4) 8mm Flat Washers and (2) 8mm Nylon Lock Nuts, (Figures 4 & 5). Snug but do not fully
tighten Bracket hardware.
5. Move toward the center of the cab, (Figure 6). Locate the pair of holes along the pinch weld. Use
Figure 1 to determine the correct mounting location for the rear Bracket. Repeat Steps 2—4 to install
(1) Driver side Mounting Bracket on the center location, (Figure 7).
6. Move toward the rear of the cab, (Figure 8). Locate the last pair of holes along the pinch weld. Use
Figure 1 to determine the correct mounting location for the rear Bracket. Repeat Steps 2—4 to install
(1) Driver side Mounting Bracket on the rear location, (Figure 9).
7. Once the (3) Brackets have been fully installed, select (1) Running Board. Place the Running Board on
top of the Brackets. Locate the channels in the bottom of the Running Board. Select (3) 8mm Double
Bolt Plates, (Figure 10). Insert the Bolt Plates into the channels in the bottom of the Running Board
closest to the Brackets, (Figure 11). Lift the Board up and guide the studs through the Brackets.
8. Attach the Running Board to the Brackets with (6) 8mm Flat Washers and (6) 8mm Nylon Lock Nuts,
(Figures 12—14).
99-16 FORD 250/350/450/550 SUPERDUTY SUPERCREW
(3) Passenger/right side
Mounting Brackets
48 8mm x 24mm x 2mm Flat Washers
12 8mm Lock Washers
24 8mm Nylon Lock Nuts
6 8mm Double Bolt Plates
(6) 8mm Double Bolt
Plates
(3) Driver/left side
Mounting Brackets
Page 1 of 4
SR2 RUNNING BOARDS
11/10/17 (RA)