Front Wheel - Baby Jogger city tour 2 Instrucciones Para El Ensamblaje

FRAME
EN
1 Unpack the stroller frame from the
box and set the wheels aside.
Unlock the stroller by pulling the
auto-lock lever.
2 Pull the lower front frame of the
stroller away from the rear legs.
Then, lift the seat back frame
upwards from the rear legs. Lastly,
unfold the handlebar upwards. The
stroller will lock into position and
you will hear a click.
3 Place the stroller in the upright
position.
WARNING: Ensure that all the
locking devices are engaged before
use.

FRONT WHEEL

4 Installation
• Attach front wheels by sliding
them into the front wheel mount
until it clicks. Gently pull on the
front wheel to make sure it is
properly attached.
5 Removal
• While pressing the front wheel
release button, gently slide the
front wheel out of the front wheel
mount.
SWIVEL FEATURE
6 Push the swivel lock button up
to lock the front wheel to a fixed
position.
7 Press the swivel lock button down
to allow the front wheel assembly to
swivel.
WARNING: When loading and
unloading child, lock the front wheel
in a fixed position. Although the
front wheel of your stroller locks, it is
not intended for jogging or exercise
purposes.
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the stroller frame
and insert it into the wheel mount
until it locks into place. You will
hear a click.
• Gently pull on the rear wheel to
make sure it is properly attached.
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
BRAKE
10 To lock the brakes: push the brake
lever down to engage the brakes.
11 To release the brakes: lift the brake
lever up.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
CANOPY
12 Pull forward to open canopy, push
backwards to close canopy.
13 To use the canopy extension: Pull
the extension out from under the
canopy until it snaps into place,
push the extension under the main
canopy to hide.
ADJUSTING SHOULDER STRAPS
14 From the back of the seat, undo the
fastening strip and open the pocket
to locate the plastic square stopper.
Turn stopper and pass through the
openings in the plastic board and
seat fabric.
15 Reinsert stopper at seat opening
closest to child' s shoulders. Pass
back through seat fabric and plastic
board. Tug on strap to ensure
stopper is locked. Repeat on both
sides.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
10
EN EN