Nostalgia Electrics CCP810 Instrucciones Y Recetas página 10

Assembly of Wheels
1. Put one #5 Flat Washer onto Axle Bolt (F) and insert into Wheel (G).
2. Put on one #4 Flat Washer. Insert Axle Bolt (F) with Wheel (G) attached into Base Support (I).
3. On the other side of Base Support (I), add a second #4 Flat Washer
and a #6 Nut Cap. Use Wrench (H) to tighten the #6 Nut Cap.
4. Repeat steps to attach second Wheel (G) onto the other side of the Base Support (I).
(F)
Axle
Bolt
(#5)
Flat
Washer
Assembly of Main Unit
1. Place Main Unit (A) onto the top of the Concession Stand (C).
2. Ensure that the two inserting pins at the bottom of the Main Unit (A) line up correctly
so that Main Unit (A) can be locked under the beam of the Concession Stand (C).
(#4)
Flat
Washer
(G)
Wheel
Base
Support
(#6)
Nut
Cap
(I)
8