Ideal Networks SignalTEK 10G Manual Del Usuario página 18

Network Test - PING4 and PING6
EN
1. Connect the display unit to the network under test
2. Set the link speed to Auto in the display unit via
RJ45 - Link Speed
Set the IP address to Dynamic (DHCP) via Settings - Network - IPv4 - IP
3.
Assignment
4. After the unit link up and acquired IP address, the tester is ready to setup
5. Set up number of PING running, Pause time, packet size and Target URL
6. Press Test key to run the test
7. To check PING result detail, click the destination URL to have more
detailed info. Repeat procedure for PING 6 Test
8. Save the results
1
4
18
www.idealnetworks.net
2
5
Settings - Network -
3
6