Ideal Networks SignalTEK 10G Manual Del Usuario página 20

Network Test - NetScan
EN
1. Connect the display unit to the network under test
2. Set the link speed to Auto in the display unit via
RJ45 - Link Speed
Set the IP address to Dynamic (DHCP) via Settings - Network - IPv4 - IP
3.
Assignment
4. After the unit link up and acquired IP address, the tester is ready to setup
Press Test key to run the test with list of network devices detected
5.
6. Change the result presentation from IP address to MAC address
7. Save the results
8. IPv6 Netscan can be done in the same procedure
1
4
20
www.idealnetworks.net
2
5
Settings - Network -
3
6