Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Network Test - Trace Route
1.
Connect the display unit to the network under test
2.
Set the link speed to Auto in the display unit via
RJ45 - Link Speed
Set the IP address to Dynamic (DHCP) via Settings - Network - IPv4 - IP
3.
Assignment
4.
After the unit link up and acquired IP address, the tester is ready to setup
5.
Set up the target of Trace Route URL, max hop, type and time out
6.
Press Test key to run the test
7.
Save the results
8.
Repeat procedure for Trace Route 6 Test
1
4
2
5
Settings - Network -
3
6
Proof of Performance
EN
19
Publicidad
Tabla de contenido
