Campbell Hausfeld TL140289 Instrucciones De Funcionamiento página 4

Operating Instructions
General Troubleshooting Guide
Symptom
Tool runs slowly or will
not operate
Moisture blowing out
of tool
Impact Mechanism Troubleshooting Guide
Symptom
Impacts slowly or will
not impact
Impacts rapidly but
will not remove bolts
Does not impact
www.chpower.com
Possible Cause(s)
1 . Grit or gum in tool
2 . No oil in tool
3 . Low air pressure
4 . Air hose leaks
5 . Pressure drops
6 . Worn rotor blade in motor
7 . Worn ball bearing in motor
1 . Water in tank
2 . Water in the air lines/hoses
Possible Cause(s)
1 . Lack of lubrication
2 . Tool regulator set in wrong
position
3 . In-line regulator or compressor
regulator set too low
1 . Worn impact mechanism
1 . Broken impact mechanism
Corrective Action
1 . Flush the tool with Campbell Hausfeld air tool oil, gum
solvent, or an equal mixture of SAE 10 motor oil and
kerosene . If Campbell Hausfeld oil is not used, lubricate the
tool after cleaning
2 . Lubricate the tool according to the lubrication instructions
in this manual
3 . a . Adjust the regulator on the tool to the maximum
setting
b . Adjust the compressor regulator to tool maximum while
the tool is running free
c . For PL2602, the regulator should be turned so the
indicator points to a number on the tool
4 . Tighten and seal hose fittings if leaks are found
5 . a . Be sure the hose is the proper size . Long hoses or tools
using large volumes of air may require a hose with an
I .D . of 1/2 inch or larger depending on the total length
of the hose
b . Do not use a multiple number of hoses connected
together with quick connect fittings . This causes
additional pressure drops and reduces the tool power .
Directly connect the hoses together
6 . Replace rotor blade
7 . Remove and inspect bearing for rust, dirt and grit or worn
race . Replace or clean and regrease bearing with bearing
grease
1 . Drain tank . (See air compressor manual) . Oil tool and run
until no water is evident . Oil tool again and run 1-2 seconds
2 . a . Install a water separator/filter . NOTE: Separators
only work properly when the air passing through the
separator is cool . Locate the separator/filter as far as
possible from the compressor .
b . Install an air dryer
Corrective Action
1 . Lubricate the air motor and the impact mechanism .
(SeeLubrication section of this manual)
2 . a . Adjust the regulator on the tool to the maximum setting
b . For twin hammer impact, the regulator should be turned
so the indicator points to a number on the tool
3 . Adjust regulators in the air system
1 . a . Replace worn impact mechanism components
b . Return impact wrench to Authorized Campbell Hausfeld
Service Center for repair
1 . a . Replace worn impact mechanism components
b . Return impact wrench to Authorized Campbell Hausfeld
Service Center for repair
4