HoMedics EnviraScape LANTERN MIST Manual De Instrucciones E Información De Garantía página 4

2. Insert the pump outlet into the water tube and align the holder notch
with the tab at the edge of the base. The fountain top will stand on the
base securely (Fig 2).
Fig 2
Water tube
Notch hole
Outlet
Pump
Tab
3. Place the oil dish on a flat surface. Fill oil dish
add a few drops of Aroma Oil to the water. Place the oil dish in dish
holder in the fountain top and make sure it is level and secure (Fig 3).
4. Cover the fountain with the fountain lid and add the clean water into the
basin. The water level should be even with the watermark (Fig 4).
Fig 4
Fountain lid
Watermark
Clear water
5
Fig 3
Oil dish
Dish holder
way with water and
5. Place the Tea Light into the Tea Light holder at the base. Light the tea light if
desired to diffuse the oil scent. Attach the adaptor to the power cord (Fig 5).
if replacement tea lights are needed, we recommend using only long burning
(5+ hours) tea lights.
Fig 5
Tea light
Switch
Tea light holder
6. Add river rocks (to the base, around tea light) and arrange as desired.
NOTE: If any splashing occurs once fountain is running, please rearrange
rocks till splashing stops
7. Plug the cord into 120V household outlet .The fountain is controlled by the
switch located on the power cord. If the pump doesn't operate, rotate in-line
switch once to turn "on" and once more to turn "off ".
Note: Ensure that the electrical cord loops below the electrical outlet to form
a "Drip Loop".This will prevent water from running down the cord into the
electrical outlet (Fig 6).
Fig 6
Drip loop
7
Adaptor
Power cord