Safety Notes; Important Notes; Functions; Information About Operation - LGB 23363 Manual De Instrucciones

Safety Notes

• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.
• WARNING! This product contains magnets. Swallowing more than one magnet may
cause death in certain circumstances. If necessary, see a doctor immediately.
• The LEDs in this item correspond to Laser Class 1 according to Standard EN 60825-1.

Important Notes

• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• The warranty card included with this product specifies the warranty conditions.
• Please see your authorized LGB dealer for repairs or spare parts.
• Disposing: www.maerklin.com/en/imprint.html

Functions

• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 – 24 volts).
• Factory-installed multiple protocol decoder (DC, DCC, mfx).
• The model is programmed with locomotive address 03 for use with the LGB Multi
Train System (DCC). The locomotive is automatically recognized in operation with mfx.
• Mfx technology for the Mobile Station/Central Station.
Name set at the factory: K'talbahn 5
• The functions can be activated only in parallel. Serial activation of the functions is
not possible (Please note here the instructions for your controller).
General-Purpose Socket
This model has a general-purpose socket for flat plugs (Fig. 3) at both ends.LGB cars
with lighting or sound electronics can be connected to the track voltage by means of
this socket.
Mode of Operation Switch
Inside the powered car is a two-position mode of operation switch (Fig. 1). You can
reach this switch by reaching through the open window. The mode of operation switch
offers the following functions (Fig. 2):
Pos. 0 locomotive stored without current
Pos. 1 everything on
Sound
The bell can be triggered with the included LGB sound switching magnet (17050). The
switching magnet can be clipped between the thresholds of most LGB tracks.
The magnet is positioned to the side under the LGB logo cast into the plastic cover.
Place the magnet on one side to trigger the "short bell" when the locomotive crosses
this spot. If arranged on the other side, the "bell sounds long".
General Note to Avoid Electromagnetic Interference:
A permanent, flawless wheel-rail contact is required in order to guarantee operation
for which a model is designed. Do not make any changes to current-conducting parts.
8