Vortice MG Folleto De Instrucciones página 11

" " "
" "
"
ENGLISH
"
"
to which the appliance is to be "
" "
connected must be able to provide
the maximum electrical power " "
required by the appliance. "
Otherwise contact an electrician to
make the necessary modifications " " "
before proceeding. " "
• Switch off the appliance at the "
" " "
installation's main switch: a) if the " " "
"
appliance does not function "
"
correctly; b) before cleaning the "
" " "
outside of the appliance; c) if the " "
" "
" " "
appliance is not to be used for any
"
length of time. "
"
" "
"
• The room must have an adequate " " " "
"
"
source of replacement air for this
" "
appliance to function effectively. " "
" "
Moreover, if there is any non-
"
sealed combustion based
appliance such as a water heater,
" " "
gas stove, etc. in the same room,
" "
air replacement must be sufficient
"
for all appliances to work
" " "
effectively together.
"
• The appliance must either exhaust
"
directly to the outside or into a
" "
short duct. Efficiency losses will
" " "
occur if the appliance is installed
"
in ducting subject to any
" "
appreciable back pressure.
" " " "
• The appliance cannot be used to
"
control activation of water heaters,
" "
room heaters, etc. nor must it be
connected to the hot air ducts
used by other appliances.
• The air to be extracted from the
room must be clean (i.e. free of
grease, soot, chemical and
corrosive agents, and explosive or
flammable mixtures) and must not
exceed a temperature of 50°C
(122°F) or 40°C (104°F) for MG
90/100.
• Keep the appliance's inlet and
outlet grilles free to ensure an
optimum flow of air.
• Install the appliance so that the
impeller is inaccessible from the
air outlet side as verified by
contact with the Test Finger (fig.
A), in compliance with the current
safety regulations. If this is not
possible, the relevant protection
accessory must be installed.
• For the electrical connection, use
'"+/; ,'!"1'+,&"-/0("E8F"44
1 63$10 !"#&10/ 6#8 D !"0(&"0/4&!
)&!#/ 6."'"0(!&&C; ,&"1'+,&"4$#0
+&"$#&3"-/0("E8F"44
#&10/ 6#8 :6"0(&"0(!&&"1'+,&#."* $
4$#0"6 0"$#&"0(&"1 , !
*&,, -H7!&&6"+&1'$#&"/0"/#
!&#&!)&3"% !"0(&"7! $638
" " "
" " "
" "
" "
" " "
" " "
" "
" " " "
" " " "
" " "
" "
" " " "
" " "
" "
" "
"
" "
" "
" "
"
" "
" " " "
" " "
" "
" " "
" "
" "
" " " "
" "
" " " "
" " "
" "
" " "
" "
"
" "
" "
"
" " " "
" "
" "
" "
G
1 63$10 !
G
" "
" " "
"
"
9 :6"0(&"&)&60"0(&";! 3$10"/#
"
/6#0',,&3"/6"'")&!0/1',"0$+&."/0"/#
6&1&##'!*"0 "/60&!; #&"0(&"'60/C
1 63&6#'0/ 6"0!';"I%/78 JKL8
"
9 A(&";! 3$10"4$#0"+&"1,&'6&3"'0
,&'#0"&)&!*"M"4 60(#"+*"'"5$',/%/&3
"
;&!# 68 N&% !&"1'!!*/67" $0
" "
1,&'6/67" !"4'/6&6'61&
"
;&!'0/ 6#.";,&'#&"3/#1 66&10"0(&
;! 3$10"%! 4"0(&"&,&10!/1"#$;;,*
4'/6#8
"
"
"
"
"
The appliance must
•
"
be installed by a
"
"
professionally
qualified electrician.
A multi-pole switch
•
must be used to
install the appliance.
The contact opening
"
gap must be no less
than 3 mm.
"
N.B.
In the event the exhaust fan is
mounted at a height of less than
2.3 meters, the fixed protection
grill must be attached (fig. 12).
The power-source data must be
consistent with the electrical
data shown on the name plate A.
11
" " "
" " "
" "
" "
" " " "
" "
"
" "
" " "7
" " " "
" " "
" " "
" " "
" "
" "
"
" "
" "
" "
"
" "
" "
" " "
" " "
" "
" "
" "
" " " "
" " "
"
"
" " "
" "
" " "
" " "
" "
" "
" " "
" " "
"
" "
" "
" " "
" "
" "
" "
" "
"
"
" "
"
"
" "
" "
" "
"
" "
" " "
" "
" "
" "
"
" "
" "
"
"
" " "
" "
" "
" " "
"
"
"