Silvercrest SPB 5.000 A1 Manual Del Usuario E Información De Servicio página 33

 The current consumption of the connected device is too low
(< approx. 80 mA). It is not possible to charge it with the
power bank. Please check the technical specifications of the
connected device.
 A short-circuit may have happened at the power bank
output. There can be different symptoms for this.
All 4 LEDs (5) flash at the same time.
Proceed as follows to reset the power bank: Unplug the
connected USB charging cable from the USB port (1, 2) of
the power bank. Wait approx. 10 seconds until the 4 LEDs
(5) stop flashing and then press the State of charge / START
pushbutton (4) once.
The power bank does not work at all.
To reset the power bank, briefly connect it to suitable power
adapter (5V
After resetting the power bank, reconnect the device you
want to charge. If the error persists, the USB charging cable
or the external device may be defective. Try charging a
different external device or use another USB charging cable
to check if the power bank works properly.
, min. 2.1A, not supplied).
SilverCrest SPB 5.000 A1
English - 31