Chicco ENJOY FUN Instrucciones De Uso página 20

FITTING AND REMOVING THE SUN-
HOOD
3 – Check that the clip at the centre of the
metal arch is fastened to the button on the
fabric part (diagram 3).
4 – There is a piece of elastic at each end of the
arch, inside the fabric (diagram 4A). Fasten the
elastic to each end of the arch to guarantee
a more secure hold for the hood, as seen in
Diagram 4B.
5 – Insert the two ends into slots A and B in
the middle of the carrycot until they click into
place (diagram 5).
6 – Slide the eyelet over hook to fasten the back
of the sunhood in place (diagram 6).
7 – To remove the sunhood, unfasten the eyelet
from the hook at the back (diagram 7).
8 – Then press button A (diagram 8) whilst
pulling the arch upwards.
VISOR
9 – Inside the sunhood, there is a fabric ring
between the visor and the fi rst section, which
can be used to hang the soft toys fi tted with
practical clips (diagram 9).
WARNING – only use Chicco toys with the
following codes: 71328, 71329, 71330
FITTING THE COVER
10 – Slide the eyelets over the side hooks (dia-
gram 10A) and the hook at the bottom (dia-
gram 10B) where the baby's feet will lie.
11 – Then fasten the side fl aps using the buttons
(diagram 11).
12 – To guarantee best draught-proof coverage,
fasten the side clips to the sunhood (diagram
12).
COMFORT SYSTEM – ADJUSTABLE
BACKREST
The backrest of the carrycot can be adjusted
to various positions.
13 – To raise and lower the backrest, turn the
knob on the outside of the carrycot where the
baby's head will lie (diagram 13).
WARNING: It is recommended to air the carry-
cot when it has been used for a long time.
All manuals and user guides at all-guides.com
20
CARRYCOT HANDLES
14 – The carrycot has fabric carrying handles
fi tted on both sides (diagram 14A). The handles
can be opened and closed together using the
Velcro fasteners (diagram 14B).
WASHING
The sunhood, the internal lining and the mat-
tress are all washable. Remove the slipcovers
from the sunhood and the internal lining to
wash them. Please carefully follow the washing
instructions indicated on the labels.
15 – Remove the sunhood from the carrycot
following the instructions in the "Fitting and
removing the sunhood" section, then unbutton
the metal arch from the fabric (diagram 3) and
pull the metal arch to remove it; use the other
hand to press the arches together which will
make it easier to remove them (diagram 15).
Please fi nd below the washing symbols and
relative meanings:
Hand wash in cold water
Do not bleach
Do not use a dryer
Do not iron
Do not dry clean
REVERSIBLE FABRIC
The carrycot fabric lining is reversible. Both the
sunhood and the cover can be fi tted either side
up, using the colours you prefer.
USING THE CARRYCOT AS A PRAM
This carrycot can be used as a pram when as-
sembled on a Chicco stroller frame fi tted with
the "Clik Clak" system.
FASTENING THE CARRYCOT TO THE
STROLLER FRAME
Prepare the stroller frame, fi tted with the "Clik
Clak" system, to fi t the carrycot as indicated in