Publicidad
Idiomas disponibles
Idiomas disponibles
6
• Mark the jacket
as shown.
8
• Fasten stand to pipe. Do not
pinch heating cables.
• Loop and tape extra heating
cable to pipe.
9
• Remove box nut.
O-ring
THERMAL MANAGEMENT SOLUTIONS
5/8 in
(15 mm)
Note: For 1 in (25 mm) and
smaller pipes, use adapter
(purchased separately) and
install between stand and pipe.
Pipe strap
Glass cloth tape
• Install grommet
plugs in unused
openings.
EN-RaychemJBM100A100A6-IM-H56344 03/13
7
JBM-SPA
adapter
for small
pipes
10
• Pull heating cable back
into stand as shown.
Use cable lubricant if
needed.
1 1/4 in
(32 mm)
• Repeat steps 2 through
7 for other heating
cables before continuing
to step 8.
Position
adapter
this side
up.
• Place junction box onto
stand. Align key ways
in large box hole with
alignment feature on
stand.
• Put box nut back onto
stand.
• Tighten box nut with
spanner.
5 / 10
Publicidad
