Metra 99-5027 Instrucciones De Instalación página 12

1. Secure the ISO brackets to the back of the radio housing with (2) #8 x 3/8"
Phillips screws with the front edge to the bracket inside the radio opening.
(Figure A)
2. Secure the mounting bracket to the back of the radio housing with the
(2) 3/8" Phillips pan-head screws supplied. (Figure A)
3. Slide the radio into the radio opening and secure with the radio's supplied
screws. (Figure B)
(Figure A)
Kit Assembly 99-5027
ISO DIN radio provision
4. Slide the rear support onto the mounting bracket and mount the support to the
back of the radio using the hardware included with the unit. (Figure B)
5. Snap the trim plate into the radio housing. (Figure B)
6. Locate the factory wiring harness and antenna plug in the dash. Metra
recommends using the proper mating adapters from Metra and/or AXXESS.
7. Reassemble dash in reverse order of disassembly.
(Figure B)
12
Rear support bracket
Rear view, radio