BioTel Care BGM 4 Manual Del Usuario página 45

3. You can select any mode you want by pushing the ENTER
button.
4. Take out a BioTel Care® Test Strip from the test strip
bottle. Close the bottle immediately.
5. IMPORTANT:
• Firmly insert the test strip into your
BioTel Care® BGM until it
is fully seated.
• The term "BioTel" or "Telcare"
should be facing up.
• The sample tip should be facing up.
• Continue to push the strip in
until "Apply Level 1 (2) Control
Solution" appears.
• Do not touch the sample tip
6. Use Level 1 solution for L1 mode.
Use Level 2 solution for L2 mode.
Squeeze a drop of control solution
onto a clean, dry, non-absorbant
surface. Immediately replace the
bottle cap on the control solution
bottle. Do not apply control
solution to the test strip directly
from the bottle.
7. Gently touch the tip of the test
strip to the drop of control
solution. You should see the
sample end of the test strip fill.
45