Operation Instructions - John Bunn DigiO2 Operación Manual

OPERATION INSTRUCTIONS

CAUTION: Do not use the sensor if it is damaged.
Info: Ensure the finger is dry before being inserted into the oximeter.
Info: Do not shake the finger; keep finger motionless during oximeter use.
Info: Avoid placing the device on a limb which is wrapped with a cuff for blood pressure
measurement or undergoing venous infusion.
Info: Ensure that no obstruction (contamination, scar tissue, fingernail polish, acrylic
fingernail, etc.) exists at the site where the sensor is placed; such obstruction could affect
the signal received by the sensor and result in an incorrect measurement.
Info: Vigorous exercise and electrosurgical device interference may affect the measuring
accuracy.
1. Open the clip as shown in Figure 4.
2. Insert finger into the clip's rubber cushion
(ensure that the finger is correctly positioned),
and then gently clip the finger.
3. The device will power on automatically in two
seconds, and start to display the software
version number.
JB02007-INS-LAB-RevC16
Figure 4
operation
9