Cleaning & Maintenance - Bunn MCU Manual Del Proprietário

Cafetera multiusos individual una sola taza
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEANING & MAINTENANCE
Rinse the Drawer(s) after each use. Drawers, Drip Tray and Drip Tray Cover are top rack
dishwasher safe. Occasionally wipe outside of the Coffee Maker with a mild, no citrus added
dish soap and a damp cloth.
Clean your Coffee Maker at least every 3 months. Mineral deposits may accumulate due
to impurities in the water used to brew. If deposits are not removed, they can impair the
operation of the Coffee Maker and reduce product life. The frequency of internal system
cleaning depends on the mineral content of your water (the higher the mineral content, the
more often you should perform Coffee Maker maintenance).
Insert any Drawer.
1.
Open Spin Lid on top of Coffee Maker.
2.
Fill Pour-in Bowl with 14 oz. white vinegar.
3.
Close Spin Lid.
4.
Place empty cup (greater than 14 oz. on
5.
the base.
Mineral deposits and loose coffee or tea granules may clog the Sprayhead, causing the brew
cycle to slow.
Unplug the Coffee Maker and allow it to
1.
cool (minimum 1 hour).
Remove Drawer.
2.
Facing the Coffee Maker, rotate the
3.
Sprayhead clockwise (using your fingers)
until the Sprayhead and Seal are removed.
Clean Sprayhead and Seal with mild
4.
detergent and rinse thoroughly.
A toothpick may also be used to clear
debris from Sprayhead holes.
When disassembling your Coffee Maker for cleaning, inspect the Sprayhead Seal for cracks,
tears and holes. Although the Seal should last for an extended period of time, damage can
occur through handling.
CAUTION: To prevent injury from hot water, do not use the unit if the Seal is damaged.
If damaged, call Customer Service at 800-352-2866 or visit
obtain a replacement Seal.
coffee maker cleaning
cleaning the sprayhead
inspecting the sprayhead seal
Push Brew Button to cycle vinegar
6.
through Coffee Maker.
Run three or more additional 14 oz. cycles
7.
of water through Coffee Maker to flush
remaining vinegar from Coffee Maker.
Follow the steps below to clean
8.
the Sprayhead.
CAUTION: If the Sprayhead and
Sprayhead Seal are separated,
they must be reassembled. Improper
reassembly could result in injury from
scalding water
Replace Sprayhead. rotate the Sprayhead,
5.
counter-clockwise until finger tight.
Replace Drawer.
6.
Plug in Coffee Maker to restore power.
7.
10
to
retail.bunn.com

Publicidad

Tabla de contenido
loading

Tabla de contenido