Kohler K-T130 Guia De Instalacion página 7

Valve Stem
Faceplate
Discard plaster
guard with dome.
Centering Washer
Screws
4. Install the Face Plate and Lever Handle
CAUTION: Risk of product damage to the K-306–KS valve
assembly. When using this valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
Remove and discard the plaster guard and/or dome, if installed.
Fit the faceplate and centering washer over the valve, and secure
with two screws.
Rotate the valve stem fully counterclockwise.
Lever Handle
Slide an O-ring fully onto the handle, and slide the insert over
the handle shank.
Fit the second O-ring over the handle shank. Secure with the
washer and nut.
Hand tighten the end cap to the handle.
Install the sleeve and bonnet to the valve stem.
Align the handle assembly, and secure the handle to the valve
stem with the screw.
Kohler Co.
Valve Stem
Sleeve
Bonnet
O-Ring
Long Sleeve
Handle Arm
7
End Cap
Washer
Short Sleeve
Screw
Center Cap
114497-2-CC