Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING! To minimize the risk to yourself and
others, always carefully watch the hopper and
its load when transporting or emptying it.
1.
From the rear of the dumper, insert the fork truck's
forks into the dumper's fork pockets. The fork truck's
forks are to be inserted completely.
2. Move the front of the dumper into position at the
side of the dumpster or refuse container.
3. Lift and tilt the fork truck mast forward until the
dumper is at the appropriate height to allow the
front of its frame to make contact with the top of the
container's side.
NOTE: Allow clearance for the hopper to
completely rotate forward without contacting
any obstructions.
WARNING! Care should be taken to identify all
potential hazards and comply with applicable
safety procedures before beginning work.
Only qualified individuals trained to understand
mechanical devices and their potential movements
and hazards should attempt troubleshooting and repair
of this equipment.
Repairs must only be performed by suitably trained
personnel with access to the appropriate equipment
and tools.
BEFORE EACH USE
Inspect for the following:
1.
Damaged pull handle.
2. Damage or structural deformation to the hopper or
the dumper's frame.
3. Proper latching of the locking mechanism.
4. Unusual noise or binding while dumping or
evidence thereof.
PAGE 2 OF 6
OPERATING INSTRUCTIONS CONTINUED
MAINTENANCE
1-800-295-5510
WARNING! Keep all personnel clear of the
dumper and the dumping area before
releasing the hopper.
4. The pull handle can be pulled from the rear of the
hopper.
5. Tilt the fork truck mast back, then back away from
the refuse container and slowly lower the dumper.
Dumper will automatically rotate backward and
lock in the upright position.
WARNING! Never use the dumper if any
damage or unusual motion is observed, if
it is in need of repairs or if it seems to be
malfunctioning.
Notify your supervisor or maintenance personnel if you
notice anything out of the ordinary.
MONTHLY MAINTENANCE
Inspect for:
1.
Pivot point wear.
2. Integrity of all pivot point pins.
3. Looseness, wear or damage to the casters' bearings,
mounting hardware or surface material.
4. Proper functioning of the releasing mechanism.
5. Unusual noises or movement when dumping.
6. All the information labels are in place and in good
condition.
7.
Dirt and debris in any area that could affect normal
operation or dumping motion.
uline.com
0321 IH-4187
Publicidad
