Uline H-623 Manual De Instrucciones

H-623
PUSHER TENSIONER
• Before operating the tool, review the enclosed
General Hand Tools and Strapping Safety booklet.
Only trained personnel should operate Uline
tensioner hand tools.
• Only use strap recommended for the tool. H-623
is recommended for 3/8" x .015 through 1⁄" x .031
gauge steel
CAUTION! Dangerous breakage may occur
due to excessive tensioning, possibly resulting
in severe injury or death. Tension strap in
moderation.
1. Pull strapping from cart and bring around load. Push
seal on with flat side of the seal facing outside of
strap. (See Figure 1)
Figure 1
2. Slide end of strap through bottom of seal and fold
over to form a "hook". (See Figure 2)
Figure 2
PAGE 1 OF 3
1-800-295-5510
uline.com
SAFETY WARNINGS
• Review the instructions and safety material on a
OPERATING INSTRUCTIONS
3. Push the top strap through the Rack and Flapper slot
4. Hold the tool above package and move the Tension
5. Seal the pusher seal with an appropriate heavy duty
6. With the seal secured, tilt the entire tool forward over
Pour le français, consulter la page 3.
CAUTION! Keep fingers away from areas that
can pinch or cut. These areas are primarily
located at the front of the tool.
regular basis.
WARNING! Unsafe use may result in blindness,
severe laceration, amputation or death.
and under the Gripper Dog with the seal against
the front of the tool. Be sure the strap is flush with the
inside edge of the H-623. (See Figure 3)
Figure 3
Rack and
Flapper
Gripper Dog
Lever back and forth to tension.
sealer.
the seal and back again approximately three times
to bend and break the strap.
Para Español, vea página 2.
0321 IH-623