American Standard SERIN 2064.461 Instrucciones De Instalación página 2

2
INSTALL WALL SPOUT
Remove PLASTER GUARDS (1, 1a) from VALVE BODY and
SPOUT NIPPLE (2).
Apply thread sealant to SPOUT NIPPLE (2).
Thread SPOUT MOUNT (3) onto SPOUT NIPPLE (2) using a
10 mm Hex Wrench. Tighten completely.
2a
INSTALL WALL SPOUT
Install SEAL (4) into SPOUT ESCUTCHEON (5).
Place SPOUT ESCUTCHEON (5) with SEAL (4)
onto SPOUT (6). Fig. A
Push SPOUT (6) onto SPOUT MOUNT (3).
Align SPOUT (6) and tighten SPOUT SET
SCREW (7) with 2mm HEX WRENCH
(8) supplied. Push SPOUT ESCUTCHEON
(5) against finished wall.
Install SEAL (9) into VALVE
ESCUTCHEON 10). Place VALVE
ESCUTCHEON (10) with SEAL (9)
onto VALVE (11). Push VALVE
ESCUTCHEON (5) against finished wall. Fig. B
3
INSTALL HANDLE
Push VALVE STEM (1) down to off position.
Attach HANDLE ADAPTER (2) to VALVE STEM (1) with
ADAPTER SCREW (3). Tighten fully.
Install HANDLE (4) onto VALVE STEM (1) and tighten
SET SCREW (5) with 2.5mm HEX WRENCH (6) supplied.
Install PLUG BUTTON (7) into HANDLE (4).
4
DRAIN INSTALLATION
Apply a bead of PUTTY to underside of FLANGE on DRAIN BODY (1).
Feed DRAIN BODY (1) down through lavatory.
Assembly GASKET (2) WASHER (3) and LOCKNUT (4) onto DRAIN BODY (1).
Tighten LOCKNUT (4) firmly.
Apply Teflon Tape to TAILPIECE (5) and thread onto DRAIN BODY (1).
3
1
10mm HEX
WRENCH
1a
4
Fig. A
6
5
6
8
6
5
4
LAVATORY
APPLY
SEALANT
2
3
11
7
Fig. B
10
3
7
1
2
1
PUTTY
2
3
4
5
M968918 Rev.1.9 (5/19)
9