Care Instructions - American Standard SERIN 2064.461 Instrucciones De Instalación

6
TEST INSTALLED FAUCET
Turn HANDLE to "off" position.
Remove AERATOR (1) using TOOL (2) supplied.
Turn hot and cold water supplies on. Operate
HANDLE to flush water lines thoroughly.
Check spout connections for leaks.
Check all drain connections for leaks.
Turn handle to OFF position.
Replace AERATOR (1).
7
SERVICE CAUTION
To remove or replace cartidge
Turn valve to OFF position.
Pull out PLUG BUTTON (1) and remove HANDLE SCREW (2).
Pull off HANDLE (3) and CAP (4).
Unthread CARTRIDGE NUT (5) and remove.
Pull out CARTEIDGE (6).
Inspect CARTRIDGE (6) and O-RINGS (7) for debris and
clean if necessary.
Clean MANIFOLD (8) and rinse clean.
Reinstall CARTRIDGE (6) and O-RINGS (7) onto MANIFLOD (8).
Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE
ASSEMBLY (3).
If spout drips, operate handle several times from OFF to
ON and HOT to COLD position. Do not force - handles
turn only 90˚.
ADJUST HOT LIMIT SAFEYT STOP
By restricting HANDLE rotation and limiting the
amount of hot water allowed to mix with the cold,
the HOT LIMIT SAFETY STOP (9) reduces risk of
accidental scalding. To lower the maximum hot
water temperature of your faucet, all you need to
do is adjust the setting on the HOT LIMIT SAFETY
STOP (9). Note: The HOT LIMIT SAFETY STOP (9)
is set at the maximum hot temperature setting
from the factory.
To adjust HOT LIMIT SAFETY STOP:
Remove HANDLE ASSEMBLY (3), CAP (4) and CARTRIDGE NUT (5).
Set the CARTRIDGE STEM (10) to the OFF position and rotate it
clockwise until stops. Fig. B.
Rotate the CARTRIDGE STEM (10) counter-clockwise to a colder
setting mark in the HOT LIMIT SAFETY STOP (9). Fig. C.
Lift up the HOT LIMIT SAFETY STOP (9) and rotate it to coincide
again with the stop in the base of the CARTRIDGE STEM (10). Fig. D.
Replace the HOT LIMIT SAFETY STOP (9).
Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE ASSEMBLY (3).
8

CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
Turn off hot and cold water
supplies before beginning.
2
1
2
9
5
4
1
+HOTTER
3
COLDER
9
10
10
7
6
8
9
SETTING
MARKS
A
9
10
GEAR GEAR
9
B
GEAR GEAR
M968918 Rev.1.9 (5/19)
C
D