Downloading Further Instructions - Balluff BAW M12MI-BLC35C-S04G Instrucciones Breves

BAW M12M_-BLC_ _ _-S04G
Inductive Linear Position Sensor
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The inductive linear position sensors
BAW M12M_-BLC_ _ _-S04G with IO-Link interface form a
distance measuring/positioning system together with a
machine controller (e.g. PLC) and an IO-Link master. It is
intended to be installed into a machine or system.
Opening the sensor or non-approved use are not permit-
ted and will result in the loss of warranty and liability claims
against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists with basic electrical knowledge.
The operator
is responsible for ensuring that local safety regulations are
observed. In particular, the operator must take steps to
ensure that a defect in the distance measuring system will
not result in hazards to persons or equipment.
If efects and unresolvable faults occur in the sensor,
it should be taken out of service and secured against
unauthorized use.

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
BAW M12MI-BLC35C-S04G
49.5
17
Tightening torque: 10 Nm
1 english
65.0
11.8
LED
Dimensions and function
The inductive linear positioning sensors BAW supply an
IO-Link output signal that changes in proportion to the
distance to a metallic target. Workpieces (=targets) with
variable shapes and sizes made of ferritic or non-ferritic
material dampen the sensor in various ways. Therefore,
positions, distances, and material variants can be identified
very simply.
Standard curve
Position
value
0x0FA0
0x0000
Slmin
LED display
The LED indicates the operating states of the sensor.
LED Operating state
OFF Target is within the measuring range
ON Target is outside the measuring range
BAW M12MH-BLC70G-S04G
65.0
5.6 43.9
Tightening torque: 10 Nm
File no. 1)
E117437
Slmax
Distance to the target
11.8
LED
17