Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BTL7-A/C/E/G5 _ _ -M _ _ _ _ -K(8)-SR115
Micropulse Transducer - Rod Style
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The BTL7 Micropulse Transducer, together with a machine
controller (e.g. PLC), comprises a position measuring
system. It is intended to be installed into a machine or
system. Flawless function in accordance with the
specifications in the technical data is ensured only when
using original BALLUFF accessories. Use of any other
components will void the warranty.
Opening the transducer or non-approved use are not
permitted and will result in the loss of warranty and liability
claims against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the position
measuring system will not result in hazards to persons or
equipment.
If defects and unresolvable faults occur in the transducer, it
should be taken out of service and secured against
unauthorized use.
BTL7...-SR115
34
40-1
6
1)
Mounting
25
surface
20.5
1) Unusable area
2) Not included in scope of delivery
1
english
Nominal length =
Measuring range
2)
Magnet
Version
...-K-...
...-K8-...
Downloading further instructions
A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
Dimensions and function
The BTL7 transducer contains the waveguide which is
protected by an outer stainless steel tube (rod). A magnet
is moved along the waveguide. This magnet is connected
to the system part whose position is to be determined.
1)
Damping zone
60
G
D1
G
10.2 mm
Thread
M4x4/6 deep
8 mm
No thread
File no.
E227256
Ø 79
Ø 64
6 holes for
mounting the
transducer
Publicidad
Tabla de contenido
