Downloading Further Instructions - Balluff BTL6-U101-M Serie Instrucciones Breves

BTL6-U101-M_ _ _ _ -A/B/Y/Z-S4
Transducer – Rod Style
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The BTL6 transducer, together with a machine controller
(e.g. PLC) and an IO-Link master, comprises a position
measuring system. It is intended to be installed into a
machine or system and used in the industrial sector.
Flawless function in accordance with the specifications in
the technical data is ensured only when using original
Balluff accessories. Use of any other components will void
the warranty.
Opening the transducer or non-approved use are not
permitted and will result in the loss of warranty and liability
claims against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the position
measuring system will not result in hazards to persons or
equipment.
If defects and unresolvable faults occur in the transducer, it
should be taken out of service and secured against
unauthorized use.
Error signal
Mounting surface
BTL6-...-S4
0.5 Ø 25
71
12.8
1) Unusable area
2) Not included in scope of delivery
1 english
Output signal rising:
100 %
0 %
Null point End point
B: 30-1 mm
Z: 2"-0.04"
Nominal length =
Measuring range
1)
Magnet 2)
Thread size
B: M18×1.5
Z: 3/4"-16UNF
25
Mounting surface
A: 30-1 mm
Y: 2"-0.04"
1)

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
Dimensions and function
The BTL6 transducer contains the waveguide which is
protected by an outer stainless steel tube (rod). A magnet
is moved along the waveguide. This magnet is connected
to the system part whose position is to be determined.
Number of magnets
Operation is possible with one or two magnets, where the
number can be fixed or flexible.
1)
Damping zone
60
Thread
M4×4/6 deep
45
46
2)
Thread size
A: M18x1.5
Y: 3/4"-16UNF
File No.
E227256