ETI Solid State Lighting 54296146 Guía De Uso Y Cuidado página 7

Installation - Strip Lights (continued)
7
Installing Non-shunted Sockets
□ Push the non-shunted sockets (C) through the proper holes
in the brackets (B) until they snap into place. For 8-ft. Strip
Lights that require the center section, two (2) non-shunted
sockets (C) will be back-to-back when installed correctly.
9
Mounting the Retrofit Brackets
□ Install the two (2) end brackets (B) and secure them using
the self tapping screws (BB).
□ For 8-ft. Strip Lights, verify the proper placement of the
center bracket by using an actual 4-ft. LED linear tube (A)
to check the distance between brackets (B) before securing
the center section with the self-tapping screws (BB).
NOTE: Use center bracket for 8-ft. Strip Lights only.
10
Installing the Housing Front Cover(s)
□ Reinstall the housing front cover(s).
□ Affix the UL Safety Sticker (CC) in a visible location.
C
B
C
B
8
Wiring the Sockets
□ Push the solid copper jumper wires (AA) into the holes on
the non-shunted sockets (C).
□ For 8-ft Strip Lights that require four 4-ft. LED linear
tubes, wire the four center sockets as shown in the
wiring diagram at right.
C
C
AA
B
C
BB
7
Please contact 1-855-384-7754 or further assistance.
AA
B
C
BB
C
C
B
C
C
BB
BB
C
WWW.ETiSSL.COM