Installation Options; Connection Modes - ETI Solid State Lighting 54296146 Guía De Uso Y Cuidado

Installation Options

The LED Retrofit Kit can be used to convert existing fixtures with up to four fluorescent T12 or T8 tubes.
NOTE: The brackets created from the Retrofit Bracket Plate (B) will not be required to convert some fixture types.
STRIP LIGHTS
Primary Application: 8-ft. Strip Lights
□ The conversion of 8-ft. Strip Lights requires the use of retrofit brackets created from the included Retrofit Bracket Plate (B).
Secondary Application: 4-ft. Strip Lights
□ When converting a 4-ft. Strip Light, only the two (2) end sections of the Retrofit Bracket Plate (B) are needed.
□ Depending on the fixture, the existing fixture brackets may be able to be used instead.
OTHER 4-FT. FIXTURES
□ The conversion of other types of 4-ft. fluorescent fixtures is less common using this LED Retrofit Kit, as the Retrofit Bracket Plate (B) is
not needed. Only the Non-shunted Sockets (C) will be required.

CONNECTION MODES

8-ft. Strip Lights
L N
L N
4-ft. Fluorescent Lights
L N L N L N
L N
5 WWW.ETiSSL.COM
Please contact 1-855-384-7754 or further assistance.