Care And Cleaning; Troubleshooting - ETI Solid State Lighting 54296146 Guía De Uso Y Cuidado

Care and Cleaning

CAUTION: Before attempting to clean fixture, disconnect the power to the fixture by turning the breaker off or removing the fuse from the
fuse box.
□ Clean the fixture with a soft, dry cloth.
□ Do not use cleaners with chemicals, solvents, or harsh abrasives.
□ Do not use liquid cleaner on the LEDs, LED driver, or wiring inside the light fixture.

Troubleshooting

Before doing any work on the fixture, disconnect power to the light fixture.
WARNING:
Minor problems often can be fixed without the help of an electrician.
Problem
The fixture will not light.
The fuse blows or the circuit breaker
trips when the light is turned on.
Possible Cause
The power is off.
The circuit breaker is off.
There is a bad connection.
There is a defective switch.
The LED tubes are installed incorrectly.
The wires are crossed or the power
wire is grounding out.
10 10
Solution
Ensure the power supply is on.
Ensure the circuit breaker is in the on position.
Check to ensure proper wire connections are made.
Contact a qualified electrician.
Contact a qualified electrician.
Install LED tubes with the end labeled "power this
end" to the wired sockets.
Check the wire connections.
Contact a qualified electrician or call customer
service 1-855-384-7754.