Help With Problems; Error Table; Emergency Operation When Batteries Are Flat; Restoring The Factory Setting - Honeywell Home TheraPro HR90 Manual Del Usuario

11. HELP WITH PROBLEMS

Error table

Problem/Display
Battery flashes Batteries flat
E1 sensor Device defective Replace the
E2 valve Motor can not be
moved.
The radiator The radiator
stays hot valve does not
close fully.
The room does Heating is not
not heat up switched on in
during time
optimization
Motor does not Valve baseplate
move not interlocked
Emergency operation when
batteries are flat
1. Unlock the radiator controller. To do so, push the
slide at the radiator controller towards unlocked.
2. Pull the radiator controller off the valve base-
plate.
3. Operate the radiator valve by hand using the
adjustment dial on the valve baseplate.
+

Restoring the factory setting

1. Keep the PROG button pressed for approxi-
mately 10 seconds until Parameter 1 flashes
(left-hand digit).
2. Use the adjustment dial to select Parameter 19
(left-hand digit) and Setting 1 (right-hand digit).
Cause Remedy
Replace the
batteries.
device.
Check the
installation.
Check the
installation. If
appropriate,
change to full-
stroke mode
(Parameter 8).
Ensure that the
pre-controller
switches on the
heating.
Synchronize the
on/off times of
boiler control
and radiator
controller.
Set the slider to
the locked
position.
–
M35651
3. Press the OK button to restore the factory set-
ting.

12. TECHNICAL DATA

Type: HR90
Supply voltage:
Battery type LR6, AA, AM3 Alkaline: 2 x 1.5 V
Lithium: 2 x 1.5 V
NiMH: 2 x 1.2 V
Power consumption:
Standby: typ. 165 mW
Control: typ. 240 mW
Control accuracy (CA): 33 °F
Connection to the radiator: M30 x 1.5
Ambient temperature: 32 ... 122 °F
Transport and storage temperature: –4 °F ... 149 °F
Dimensions: 3-25/32" x 2-1/8" x 2-23/64"
Weight: 6.5 oz (with batteries)
Ambient conditions:
For living area, business and trade sections as well as
small businesses
Humidity: 10-90% Relative Humidity
Standards:
EN55014-1:2006 +A2:2011
EN55014-2:1997 +A2:2008
EN60730-1:2011
EN60730-2-9:2010
RoHS 2011/65/EC
CE
13. DISPOSAL
The radiator controller has to be disposed of in
accordance with WEEE directive 2012/19/EC – Waste
Electrical and Electronic Equipment directive.
• At the end of the product life dispose of the
packaging and product in a corresponding
recycling centre.
• Do not dispose of the unit with the usual domestic
refuse.
• Do not burn the product.
• Remove the batteries.
• Dispose of the batteries according to the local
statutory requirements and not with the used
domestic refuse.
11
THERAPRO HR90
33-00084EFS—03