Conceptronic 150N Manual Del Usuario página 15

5.3 Connect automatically using the WPS PIN Code function
When your router or access point is WPS capable, but does not have a (virtual) push button, you can
create a WPS connection using the PIN Code function.
Note: Your wireless router or access point needs to have the WPS PIN Code function in its web interface
in order to use this function.
The wireless utility can work in "Enrollee" or "Registrar" mode:
- When "Enrollee" is selected, the wireless utility will generate a PIN Code which must be entered in the
WPS configuration of your router or access point.
- When "Registrar" mode is selected, you can enter a PIN Code in the wireless utility. This mode is
needed when your router or access point provides a PIN Code which must be used for the wireless
connection.
- Activate the WPS PIN Code function on your router or access point.
- Select the correct "Config Mode" in the wireless utility, according to the information above.
- Click on the "PIN" button in the wireless utility.
You can see the WPS activity at the bottom of the window:
When the WPS PIN Code authentication is completed successfully, the message "PIN – Get WPS profile
successfully" will be shown shortly.
- Select the newly created WPS profile from the 'WPS Profile List' and click on "Connect" to establish
the wireless connection.
You are now connected to your wireless network. The wireless utility will indicate the signal strength in
your system tray:
ENGLISH
15